VOLTCRAFT VC271 SE Operating Instructions Manual page 40

• Always remove the test probes from the measured object before changing the measurement range.
• The voltage between the multimeter connection points and earth must never exceed 600 V DC/AC in
CAT III.
• Exercise particular caution when working with voltages higher than 33 V (AC) and 70 V (DC). Touching
electrical conductors with these voltages may cause a fatal electric shock.
• To prevent an electric shock, do not touch the measuring points when taking measurements, either
directly or indirectly. When taking measurements, do not touch any area beyond the grip markings on
the test probes / test leads.
• Check the measuring device and test leads for signs of damage before each measurement. Never take
measurements if the protective insulation is damaged (torn, missing, etc.). The test leads come with
a wear indicator. A second layer of insulation will become visible if the lead is damaged (the second
layer of insulation is a different colour). If this occurs, discontinue use and replace the measurement
accessory.
• Do not use the multimeter immediately prior to, during or just after a storm (risk of electric shock / power
surge). Ensure that your hands, shoes, clothes, the floor, circuit and circuit components are dry.
• Avoid using the device in the immediate vicinity of:
- Strong magnetic or electromagnetic fields
- Transmitting antennas or HF generators.
• These may distort the measurements.
• If you suspect that safe operation is no longer possible, discontinue use immediately and prevent unau-
thorized use. Safe operation can no longer be assumed if:
- There are signs of damage
- The device does not function properly
- The device was stored under unfavourable conditions for a long period of time
- The device was subjected to rough handling during transport
• Do not switch the device on immediately after it has been brought from a cold room into a warm one.
The condensation generated may destroy the product. Leave the device switched off and allow it to
reach room temperature.
• Do not leave packaging material lying around carelessly, as it may become a dangerous toy for children.
• Observe the safety information in each section.
40