Loading The Saved Content Of The Hard Disk To The Br-1180Cd (Hdd Recover); Copying And Writing Waveform Data; Copying Waveform Data From A Computer To The Audio Tracks (Wav/Aiff Import) - Boss BR-1180 Owner's Manual

Using the CD-R/RW to exchange data (BR-1180CD)
Loading the saved content of the hard
disk to the BR-1180CD (HDD Recover)
1. Place the CD-R/RW disc containing the saved hard disk
data in the CD-R/RW drive.
2. After the CD-R/RW drive's indicator has stopped
flashing, press [DATA SAVE/LOAD].
3. Use [CURSOR] to select the "RECOVER" icon then
press [ENTER].
fig.R16-06
4. Using [CURSOR] again to move the cursor to "HDD,"
then press [ENTER].
The message "HDD Recover Ok?" appears.
fig.R16-55
5. Press [YES], and when the message "Initialize HDD?"
appears, press [YES] again.
The hard disk is initialized, then the recovery begins.
When "Complete!" appears, the loading is finished.
When you execute HDD Recover, all data stored on the
hard disk up to that point is erased and overwritten by
the data on the CD-R/RW disc. Note that this data
cannot be recovered once it has been erased.
116
Copying and writing
waveform data
* This procedure requires a computer equipped with a drive
capable of writing to CD-R/RW discs.
If you have a computer equipped with a CD-R/RW drive,
you can use CD-R/RW discs to transfer waveform data
between multiple BR-1180CDs.
You can, for example, use these discs to copy waveform data
created with the audio software on your computer and then
paste the data to audio tracks. You can also take audio track
data recorded with the BR-1180CD and copy it to your
computer for editing.
Copying waveform data from a computer
to the audio tracks (WAV/AIFF Import)
1. First, write the waveform data you want to import to a
CD-R/RW disc.
Finalize (p. 106) the CD-R/RW disc to which the data
has been written.
* Use "ISO 9660 Level 2, Mode 1" to write the data to the CD-
R/RW disc. The BR-1180CD may be unable to load the data if
a different format is used.
* Waveform data must be 8- or 16-bit WAV or AIFF format. In
addition, only a sampling rate of 44.1 kHz can be used. No
data in any other format can be copied.
* Compressed WAV files or AIFF files cannot be loaded.
* Extremely short waveform data (less than approximately 500
ms) cannot be loaded.
* The loop point settings within an AIFF file will be ignored.
* Name waveform data using eight letters followed by a three-
character extension. File names not in this format may not be
displayed correctly in the BR-1180CD's screen.
* For instructions on how to write waveform data to CD-R/RW
discs, refer to your computer and CD-R/RW drive owner's
manuals.
2. Place the CD-R/RW disc containing the copied hard
disk data in the BR-1180CD's CD-R/RW drive, then
press [DATA SAVE/LOAD].
3. Use [CURSOR] to select the "WAVE MENU" icon, then
press [ENTER].
The Menu screen appears.