Operation - Craftsman 247.889800 Operator's Manual

Recoil Starter Handle
Gas Cap
Chute Assembly
Shave Plate
Auger
Now that you have set up your snow blower, it's important to become acquainted
with its controls and features. Refer to Figure 13.
Choke Control
RUN RUN
CHOKE BELOW
Activating the choke control closes the choke plate on carburetor and aids in
starting engine. The choke lever slides between the RUN
positions.
Primer
Pressing the primer, making sure to cover the vent hole
when pushing, forces fuel directly into the engine's
carburetor to aid in cold-weather starting.
Craftsman snow blowers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Auger Control
Chute Tilt Control
Control Handle
CHOKE CHOKE
and CHOKE
Meets ANSI Safety Standards
Electric Starter
Electric Starter
Choke Lever
Oil Drain
Figure 13
Recoil Starter Handle
The recoil starter handle is used to start the engine.
Gas Cap
Remove the gas cap to add fuel.
Key
The key is a safety device. It must be fully inserted in order for the
engine to start. Remove the key when the snow blower is not in use.
NOTE: Do not turn the key in an attempt to start the engine.
Doing so may cause it to break.
Auger
When engaged, the auger rotation draws snow into the auger housing and throws
it out the discharge chute. Rubber paddles on the auger also aid in propelling the
snow blower as they come in contact with the pavement.
11
Key
Primer
Button
Outlet
Choke Lever
Muffler
Recoil
Starter
Handle
Oil Fill/
Dipstick
Electric
Starter