KTM 250 EXC-F 2021 Owner's Manual page 69

–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB
(red adjuster).
The compression damping is located in left fork
leg COMP (white adjuster).
Grooves are milled into the side of the upper end of the
V01791-10
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
–
Tighten screws
Guideline
Screw, bottom triple
clamp
V01790-10
–
Tighten screw
Guideline
Screw, top steering
head
–
Tighten screw
Guideline
Screw, top steering
stem
E01701-10
–
Tighten screws
Guideline
Screw, top triple
clamp
V01790-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
V01792-10
Finishing work
–
Mount the handlebar cushion.
–
Install front fender. (
SERVICE WORK ON THE CHASSIS 12
5
are positioned toward the front.
6
.
M8 15 Nm (11.1 lbf ft)
4
.
M20x1.5 12 Nm (8.9 lbf ft)
7
.
M8 20 Nm (14.8 lbf ft)
8
.
M8 20 Nm (14.8 lbf ft)
M8 25 Nm (18.4 lbf ft)
bk
.
p. 73)
9
.
Loctite ® 243™
67