Table of Contents
Advertisement
Notification Tones
When you perform a touch button and keyboard key
combination operation (page EN-10), a notification tone will
sound when you press the keyboard key to let you know the
result of the operation. Notification tone types are described
below.
■ Notification Tone Types
This type of
When this happens:
tone sounds:
Received
A keyboard key operation is received and
tone
applied. This tone sounds if a setting is
enabled (turned on) when you press a
keyboard key that toggles the setting
between enabled and disabled.
Invalid tone
You press the wrong keyboard key. This
tone lets you know the operation is invalid.
Upper limit,
You press a keyboard key that would cause
lower limit
the setting to become greater than the
tone
upper limit or less than the lower limit.
Initialization
Settings were returned to the initial defaults.
tone
This tone sounds when you press the plus
(+) and minus (–) keyboard keys at the
same time, etc.
Option tone
A setting option is changed by pressing a
keyboard key that cycles through options.
The number of times the tone sounds
depends on the option that is selected.
Off tone
A setting is disabled (turned off).
Reference
As you use the plus (+) and minus (–)
tone
keyboard keys to change a setting value, a
reference tone will sound to signal when the
keyboard key operation result in certain
types of values to be set. In the case of
whole number (non-fraction) values, the
reference tone will sound whenever the
setting becomes one that is multiple of 10
(10, 20, etc.) In the case of fraction values
(like 440.2), the reference tone will sound
whenever the setting becomes a value that
is a whole number (440, 441, etc.)
End tone
The final keyboard key was pressed for a
setting operation that requires multiple
keyboard key operations. For example,
when you input a three-digit tempo setting,
this tone will sound when you press the
keyboard key for the third digit.
■ Notification Tone Sets
Your Digital Piano comes with three different notification tone
sets from which you can choose. You can also disable
notification tones, if you want. For information about how to
change the notification tone set, see
EN-46).
"Other
Settings" (page
Listening to Demo Play
1.
Hold down 3 FUNCTION.
This causes the DEMO light to flash, and the
4 SOUND MODE light to turn light (and the lights of
other buttons to turn off).
2.
Touch 4 SOUND MODE.
This will cause the 6 a and DEMO lights to light,
and starts playback of the one demo song (and the lights
of buttons except for 6 a to turn off). After demo
song playback is complete, it will continue with playback
of Music Library (page EN-26) songs.
• The operations below are supported during demo play.
A0
C1
C2
C3
B0
B 0
C1 - A1
To do this:
Skip forward to the next
song
Skip back to the previous
song
Jump to a specific song
Jump to a song by inputting
its number
Return to the first song
(demo song)
• For information about how to input song numbers and
the keyboard keys you should use for input, see
"Inputting Song Numbers Using the Song Selection
Keyboard Keys
(10-key)" (page EN-10). For a list of
songs, see the
"Music Library
3.
To stop demo song playback, touch 6 a.
This causes the button lights that turned off in the above
procedure to light again.
• If Auto Power Off is enabled, power will turn off
automatically after the prescribed time even during demo
song play. To avoid this, you can use the procedure under
"To enable or disable Auto Power
disable Auto Power Off.
C4
C5
C6
C7
C2 - B6
Perform this operation:
While holding down 6 a,
press the B0 keyboard key.
While holding down 6 a,
press the B}0 keyboard key.
While holding down 6 a,
press a keyboard key from C2
through B6.
While holding down 6 a,
input a song number (0 to 60)
by pressing a keyboard key
within the range of C1 through
A1.
While holding down 6 a,
press the B}0 and B0
keyboard keys at the same
time.
List" (page EN-64).
Off" (page EN-7) to
EN-11
C8
Advertisement
Table of Contents
