Table of Contents
Advertisement
6. Installing Indoor Unit
Preparation
●Open the front panel, remove the 4 screws and dismount
the front grille while pulling it forward.
●Follow the arrows to disengage the clasps on the
front case to remove it.
●Follow the procedure below when removing the slit portions.
■For Moldings
●Remove the pillars. (Remove the slit portions on the
bottom frame using nippers.)
■For Side Piping
●Remove the pillars.
(1) Remove the 7screws.
(2) Remove the upper casing (2 tabs).
(3) Remove the left and right casings (2 tabs on eachside ).
(4) Remove the slit portions on the bottom frame and
casings using nippers .
(5) Return by following the steps in reverse order(3>2>1).
Installation
●Secure using 6 screws for floor installations.(Do not forget to secure to the rear wall.)
●For wall installations, secure the mounting plate using 5 screws and the indoor unit using 4 screws.The mounting plate should be
installed on a wall which can support the weight of the indoor unit.
(1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring points on the
wall.
(2) Secure the mounting plate to the wall with screws.
Floor Installation
48
Casing
Remove the pillar
Casing
6screws
Front panel
Remove 4 screws
3)Side
casings
Wall Installation
6screws
Service Manual
3 tabs
Casing
Front
grille
Remove
front grille
Open the front panel
2)Upper casing
Remove 7 screws
Remove the pillar
Bottom frame
Casing
Remove the pillar
Molding
Installation and Maintenance
3)Side
casings
Advertisement
Table of Contents
