Hfu 4520D With Usb (Com-Port-Emulation); Triggering /Activation - Leuze electronic HFU 4520D Short Description

HFU 4520D with USB (COM-Port-Emulation)

To use the HFU 45xxD with USB you use the standard RS232 cable and connect the
USB Converter cable. The data is sent to the new COM-Port. The necessary driver is available on
www.leuze.de. the interface is set to 9600,8,N,1.Separate power supply needed.
Necessary parts:
1x 50114138 HFU 4520D, incl. battery
1x 50110676 NT Hx5x0, Power supply (100-240VAC/6VDC)
1x 50110672 Base Hx520, Bluetooth base
1x 50110675 KB-RS232-Base Hx520, RS232 cable, 2m length
1x 50110677 KB-USB-RS232, converter cable, 1m length
USB-converter cable KB-RS232-USB, Length 1m
Pinning of the USB-connector, 9 pin Sub-D like above
Note: Operation with external power supply recommended
USB-Type A-Plug
1
2
3
4

Triggering /Activation

For starting the SCAN operation / activation signal (trigger) you use the Trigger button at the handle of the
device.
Short description HFU 4520D
Signal
VCC IN
Data -
Data -
GND
Leuze electronic
Art-No. 50110677
Description
5 VDC
Data -
Data +
Signal Ground
Page 18