Device Reset / Factory Default; Parameter Setting - Leuze electronic HFU 4520D Short Description

Systems menu
Run Program Start of function selection
RFID Parameter Setting for Transponder Start block and number of blocks separate for
READ and WRITE op. Input via keys, OK for acknowledge
BarCode Pre select of Barcode(Symbology), with No of digits,
Choice with Green (* as character on Display)
Data output Prefix/Suffix, preset STX(02)/CRLF(0D0A)
Select HEX/ASCII for all functions, pre set ASCII
Data format:
Data output:: Full/ DATA only / OFF, pre set Full
full means complete telegram (RFID)
Interface Baud rate and Databits can be set between 4800Bd and 115kBd ,
pre set 9600Bd, 8N1
Keyboard Password via Com/Password ON/OFF
MoreMessages: activation of different messages, select with Green (* as character in Display)
Device Settings Pre setting Region (UHF-Band) and power level
The complete menu structure is in the chapter menu.

Device reset / Factory default

With selecting the menu point "Reset device" in the System menu the device can be reset to factory default.
Note: All individual settings are lost then!!!

Parameter Setting

All parameters are available and can be set via key board in different sub menus within the system menu. No
separate or special software tool is needed.
Short description HFU 4520D Leuze electronic Page 11