Lenovo ThinkSystem SR675 V3 Manual page 167

User Action:
Information only; no action is required.
• FQXSFPU4084I: Host boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4085I: Host WOL boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFSM0002N: Boot Permission denied by Management Module: System Halted.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Check XCC logs,and make sure the PSU installation follows support guide line.
3. Review power policies and system configuration settings in the XCC GUI.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0003N: Timed Out waiting on boot permission from Management Module: System
Halted.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Check XCC logs,and make sure the PSU installation follows support guide line.
3. Review power policies and system configuration settings in the XCC GUI.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0004M: An XCC communication failure has occurred.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Make sure XCC and UEFI FW are operating with same compatible level.
3. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error.
4. Reflash XCC Firmware.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0007I: The XCC System Event log (SEL) is full.
Severity: Info
. 163
Chapter 3 UEFI events