Brother HL-L3230CDW Online User's Manual page 218

Error Message
Limit Exceeded
Manual Feed
Media Type Mismatch
No Belt Unit
No Drum Unit
No Paper Tray1
No Toner
No Tray1
No Waste Toner
Out of Memory
Print Data Full
Print Unable ##
Registration
Cause
The print limit set in Secure
Function Lock 3.0 was reached.
Manual was selected as the paper
source in the printer driver, but
there is no paper in the manual
feed slot.
The media type specified in the
printer driver differs from the
paper type specified in the
machine's menu.
The belt unit is not installed or not
installed correctly.
The drum unit is not installed
correctly.
The machine failed to feed paper
from the indicated paper tray.
The toner cartridge is not installed
or not installed correctly.
The paper tray is not installed or
not installed correctly.
The waste toner box is not
installed or not installed correctly.
The machine's memory is full.
The machine's memory is full.
The machine has a mechanical
problem.
Registration failed.
Action
Ask your administrator to check your Secure
Function Lock Settings.
Place paper in the manual feed slot.
Load the correct type of paper in the tray
indicated on the LCD, and then select the
correct media type in the Paper Type setting
on the machine.
Reinstall the belt unit.
Reinstall the toner cartridges and drum unit
assembly.
Do one of the following:
• Refill paper in the paper tray indicated on
the LCD. Make sure the paper guides are
set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
• Do not overfill the paper tray.
Remove the toner cartridge and drum unit
assembly. Remove the toner cartridge from the
drum unit, and reinstall the toner cartridge
back into the drum unit. Reinstall the toner
cartridge and drum unit assembly back in the
machine. If the problem continues, replace the
toner cartridge.
Reinstall the paper tray indicated on the LCD.
Reinstall the waste toner box.
Press and reduce the print resolution.
Press and delete the previously stored
secure print data.
• Press and hold to turn the machine off,
wait a few minutes, and then turn it on
again.
• If the problem continues, contact Brother
customer service.
• Press and hold down
machine off. Wait a few seconds, and then
turn it on again. Perform the colour
registration again using the LCD.
• Install a new belt unit.
• If the problem continues, contact Brother
customer service or your local Brother
dealer.
to turn the
213