Bissell PROHEAT 2X 8930 Series User Manual page 6

Operations
Special features
Your bissell PROheat 2X deep cleaner is a
home cleaning system that uses the power of
heat, brushes and cleaning formula to get the
deep down dirt for a maximum clean. Not only
does it come with several unique features, it has
been designed with you, the customer, in mind.
built-in-Heater feature
bissell PROheat 2X models all feature a
patented built-in heater which will heat the
hot tap water you put in up to 25 degrees hot-
ter to safely optimize cleaning effectiveness.
The heater will never allow the temperature to
exceed 190°F. The heater switch on the front of
the machine controls the heater so you have the
option to turn off the heat if you are cleaning
delicate wool or oriental rugs.
2-in-1 Water tank
Our 2-in-1 water tank full capacity system is
designed with a heavy duty bladder inside for
clean water. As you clean, the clean water in the
bladder will empty and mix with the cleaning
formula. Dirty water pulled out of your carpets
will collect around the outside of the bladder so
that clean and dirty water are always kept sepa-
rate. This allows the user to only carry one tank
to and from the sink for emptying and filling.
Readytools™ Dial
This provides either floor cleaning or above
floor cleaning with the turn of a knob. Choose
"TOOls" setting for stairs, upholstery and
hard to reach areas and "FlOOR CleANiNG"
for carpets, area rugs and bare floors.
before you clean
1. Move furniture to another area if cleaning an
entire room (optional).
2. Pick up all loose dirt, debris, and pet hair
before deep cleaning. if you're cleaning just a
small area of carpeting or less than a whole
room, the ProHeat 2X Deep Cleaner may be
used to vacuum the area before deep cleaning.
if so, be sure to keep the red filter screen (in the
2-in-1 tank lid) cleaned of lint so that suction
is maintained. When you're done, clear the red
filter screen and then rinse both the dirty water
and the clean solution tank (inside the flexible
bladder) with warm water before starting the
deep cleaning process.
3. Plan your cleaning route to leave an exit path.
it is best to begin cleaning in the corner farthest
from your exit.
www.bissell.com
6
800.237.7691
WaRnInG
Do not plug in your cleaner until you have
completely assembled it per the above
instructions and are familiar with all
nstructions and operating procedures.