HP EliteDesk 800 G3 SFF Hardware Reference Manual page 31

Hide thumbs Also See for EliteDesk 800 G3 SFF:

Slide the optical drive through the front bezel all the way into the bay (1) so that the latch on the rear of

the drive locks into place (2).

10.

Connect the power cable (1) and data cable (2) to the rear of the drive.

11.

Connect the opposite end of the data cable to one of the light blue SATA connectors on the system board

labeled SATA1 or SATA3.

NOTE:

Refer to

System board connections on page 13

connectors.

12.

Replace the front bezel if it was removed.

13.

Replace the computer access panel.

14.

If the computer was on a stand, replace the stand.

15.

Reconnect the power cord and any external devices, and then turn on the computer.

16.

Lock any security devices that were disengaged when the access panel was removed.

for an illustration of the system board drive

Removing and installing drives