Cutting Height; Pattern; Operation - Husqvarna AUTOMOWER 550 EPOS Operator's Manual

4.2 Cutting height

The cutting height is set individually for each work area.
The cutting height can be set to 20-60 mm / 0.8-2.4 in.

4.3 Pattern

The settings for the pattern is set for each work area.
You can do these settings:
• Set the pattern for how the product operates.
• Set the direction of the pattern.
Border mowing . With Fixed
• Set the type of the
border mowing the product always operates in
the same paths to keep a sharp border around
Variable border mowing , the
the work area. With
product operates in different paths to decrease the
risk of track marks along the virtual boundary.
• Set a pattern that includes a number of directions
in work areas that includes many obstacles and
stay-out zones.
Husqvarna recommends to use systematic pattern on
large and open work areas. The systematic pattern can
make track marks on the lawn. If you use systematic
pattern on a work area with obstacles, make stay-out
zones around obstacles and use a pattern with many
directions for a satisfactory cutting result.
Husqvarna recommends to use irregular pattern if the
work area is complex and has many obstacles.

4.4 Operation

In the Operation's menu it is possible to change the
settings of the Weather timer, ECO mode and Spiral
cutting .
4.4.1 Spiral cutting
If the product enters an area where it senses the grass
is longer than average, it can change the movement
pattern to Spiral cutting . This means that the product
mows in a spiral pattern to faster cut the area with
longer grass. It is possible to set the intensity of the
Spiral cutting . Very low / Low intensity means that Spiral
cutting begins less often. High / Very high intensity
Spiral cutting begins more often.
means that
22 - Settings
Note:
Spiral Cutting does not start in slopes steeper
than 15%.
4.4.2 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
When using Weather timer , it is recommended
to make as much operating time as possible available
for Weather timer . Do not restrict the schedule more
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
Weather timer selects if the product will
and then
continue to operate or not.
Note:
Weather timer is reset if the product does not
operate for more than 50 hours, or if a
settings is done. Weather timer is not changed if a Reset
of schedule settings is done.
4.4.3 ECO mode
ECO mode is enabled, it switches off the signal in
If
the charging station, when the product is parked or is
charging.
Note:
Use ECO mode to save energy and prevent
interference with other equipment, for example hearing
loops or garage doors.
Note:
To start the product manually in the work area,
push the STOP button before you remove the product
from the charging station. If not, the product cannot park
at the charging station.
Reset of all user
1576 - 006 - 27.01.2023