Baofeng UV-17R Series User Manual page 38

AL-MOD
32
- Alarm Mode
STE
33 - Squelch Tail
Elimina�on
RP-STE - Squelch Tail
34
Elimina�on
RPT-RL
35 - Delay the squelch tail
of repeater
36 ROGER - Roger Beep
37 TONE-Tone-burst
38 MENU EXIT TIME
39 VOX DELAY
POWER ON MSG
40
- Power On Message
voice encryp�on
41
RESET
42
- Restore defaults
SITE [0]: Sounds alarm through your radio
•
speaker only
TONE[1]: Transmits a cycling tone
•
over-the-air
CODE [2]: Transmits '119' (911 in reverse)
•
followed by the ANI code over-the-air
OFF [0] | ON [1]
OFF [0] | 1 - 10
OFF [0] | 1 - 10
OFF [0] | ON [1]
1000[0]|1450[1]|1750[2]|2100[3]
5 [0] 10[1] - 60[10] in 5 second steps
(TIMEOUT-5)/5=[n]
0.5 [0] 0.6[1] -2.0[15] in 0.1 second steps
(TIMEOUT-0.1)/0.1=[n]
LOGO[0]|VOLTAGE[1]
OFF [0] | ON [1]
VFO [0] | ALL [1]
35
SITE: Sounds alarm through your radio speaker
•
only
TONE: Transmits a cycling tone over-the air
•
CODE: Transmits '119' (911 in reverse?)
•
followed by the ANI code over-the-air
This func�on is used eliminate squelch tail noise
between BaoFeng handhelds that are
communica�ng directly (no repeater).
Recep�on of a 55 Hz or 134.4 Hz tone burst
mutes the audio long enough to prevent hearing
any squelch tail noise.
This func�on is used eliminate squelch tail noise
when communica�ng through a repeater.
Delay the Tail Tone of Repeater (X100
milliseconds)
Sends an end-of-transmission tone to indicate to
other sta�ons that the transmission has ended.
To send out a tone-burst; you simultaneously will
press a key while holding down the PTT. No
further configura�on required using this feature.
The �me se�ng for menu exit without menu
opera�on.
There's a brief delay between when you finish
talking and the radio returns to tx mode; this
delay can be adjusted.
Welcome message displayed immediately a�er
startup.
The LOGO is programmed by the manager.
Ac�vate the frequency hopping func�on to
prevent interference from outside the group
Resets the radio to factory defaults, with some
excep�ons.