Baofeng UV-17R Series User Manual page 37

MDF-A
24 - Channel Mode A
Display
MDF-B
25 - Channel Mode B
Display
BCL
26 - Busy Channel
Lock-out
AUTOLK – Automa�c
27
Keypad Lock
SFT-D
28 - Frequency Shi�
Direc�on
OFFSET - Frequency
29
shi� amount
MEMCH - Store a
30
Memory Channel
DELCH - Delete a
31
memory channel
CH [0]: Displays the channel number
•
NAME [1]: Displays the channel name.
•
FREQ [2]: Displays programmed Frequency
•
CH [0]: Displays the channel number
•
NAME [1]: Displays the channel name.
•
FREQ [2]: Displays programmed Frequency
•
OFF [0] | ON [1]
AUTOLK：OFF ON
OFF [0]: TX = RX (simplex)
•
+ [1]: TX will be shi�ed higher in frequency
•
than RX
- [2]: TX will be shi�ed lower in frequency
•
than RX
00.000 - 69.990 in 10 kHz steps
001 - 999
001 - 999
34
[A] MR/Channel Mode Display Format
Note: Names must be entered using so�ware.
[B] MR/Channel Mode Display Format
Note: Names must be entered using so�ware.
Disables the [PTT] key on a channel that is
already in use. The transceiver will sound a beep
tone and will not transmit if the [PTT] key is
pressed when a channel is already in use.
Set the automa�c keyboard lock delay �me. To
prevent the keyboard from being accidentally
triggered.
When turned on, if the keyboard is not used
within a predetermined delay �me, the keyboard
will be locked. Pressing the
seconds will unlock the keypad.
Enables access of repeaters in VFO/Frequency
Mode
Specifies the difference between the TX and RX
frequencies
This menu is used to either create new or modify
exis�ng channels (001 through 999) so that they
can be accessed from MR/Channel Mode.
This menu is used to delete the programmed
informa�on from the specified channel (001
through 999) so that it can either be
programmed again or be le� empty.
key for 2