Baofeng UV-17R Series User Manual page 27

a. Press and hold the
b. Use the numeric keypad to enter the repeater's output (your receiving) frequency.
c. Press the key to enter the menu.
d. Enter [2][9] on the numeric keypad to get to frequency offset.
e. Press key to select.
f. Use the numerical keypad to enter the specified frequency offset. See the section called "29 OFFSET - Frequency shift
amount" for details.
g. Press key to confirm and save.
h. Enter [2][8] on the numeric keypad to get to offset direction.
i. Use the / keys to select + (positive) or - (negative) offset.
j. Press key to confirm and save.
k. Optional:
a). Save to memory, see the section called "Manual programming" for details.
b). Set up CTCSS; see the section called "CTCSS" for details.
l. Press key to exit the menu. If everything went well, you should be able to make a test call through the repeater.
NOTE:
If you're experiencing problems making a connection to the repeater, check your settings and/or go through the procedure
again.
Certain Amateur Radio repeaters (especially in Europe) use a 1750Hz tone burst to open up the repeater. To see how this is
done with the radios, see the section called "1750Hz Tone-burst".
If you're still unable to make a connection, contact the person in charge of the radio system with your employer or your local
amateur radio club, as the case may be.
If you for some reason want to listen to the repeater's input frequency instead, press
your transmit and receive frequencies.
This is indicated in the LCD on the radio with an R in the top row, next to the + and - for the offset direction.
key to set the radio to VFO mode, and the VFO icon is displayed on the right.
24
key momentarily and you'll reverse