Advertisement
INSTRUMENT AND CONTROL FUNCTIONS
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
"
Press this switch to sound the horn.
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to "
4
the " " side of the switch. See page
6-1 for starting instructions prior to
starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12501
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
EAU54211
when your vehicle is stopped where it
/
"
might be a traffic hazard.
", and then push
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
" to stop the en-
tery may discharge.
Drive mode switch "MODE"
WARNING
EAU41701
Do not change the D-mode while the
vehicle is moving.
Using this switch changes the drive
mode to "STD", "A", or "B" in the fol-
lowing order:
STD → A → B → STD
The throttle grip must be completely
EAU12734
closed in order to change the drive
" posi-
mode. (See page 4-10 for an explana-
tion of each drive mode.)
TIP
The mode is set to "STD" by de-
The selected mode is shown on
ECA10062
EAU47496
EWA15341
4-12
fault. The mode resets to "STD"
when the key is turned to "OFF".
the drive mode display. (See page
4-6.)
Advertisement
