Ricoh AP610N Setup Manual page 87

Configuration
I
Set [Trans. Speed] in the same way.
❒ The factory default is [Auto]. If you need to change the transmitting speed
depending on environment you are using, select the appropriate transmit-
ting speed.
J
If [Infrastructure] or [802.11 Ad hoc] is selected for [Comm. Mode], set SSID to
use for transmission.
❒ Confirm the network administrator for SSID to use.
❒ SSID can also be set using a Web browser. For details, see the Web Image
Monitor Help, and "Using Web Image Monitor", Software Guide.
K
Press the {U} or {T} key to display [SSID], and then press the {# Enter}
key.
The following message appears on the display.
SSID:
View
If an SSID has been set, you can check the set SSID. Press the {# Enter} key.
L
Press the {U} or {T} key to display [Enter ID], and then press the {# Enter}
key.
The following message appears on the display.
SSID:
k
The value in brackets at the upper right is the number of characters entered.
M
Press the {U} or {T} key to select characters, and then press the {# En-
ter} key.
SSID:
Ak
You can now enter the next character.
N
Continue entering the key.
❒ The characters that can be used are ASCII 0x20-0x7e (32 bytes).
❒ To display the previous character, press the {Escape} key.
[ 0]
[ 1]
87