Configuring Protocols; Configuring Tcp/Ip And Ipp For Printing - Ricoh AP400 Network Manual

Windows 95/98/Me Configuration

Configuring Protocols

Configuring TCP/IP and IPP for Printing

1
These instructions are for configuring the Network Interface Board and Win-
dows 95/98/Me to use the TCP/IP protocol and IPP.
Configuring the machine
Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information about how to make the above settings, see the Setup
Guide.
If DHCP is used to assign IP addresses, see p.139 "Using DHCP".
Note
❒ After setting the IP address, use the ping command to make sure that it has
been set correctly.
A
Enable the use of the command prompt as follows:
• On Windows 95 or Windows 98
Click [Start], point to [Programs], and then click [Command Prompt].
• On Windows Me
Click [Start], point to [Programs], point to [Accessories], and then click
[Command Prompt].
B Type the following: (Example IP address is 192.168.15.16)
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
12