Ricoh AP400 Network Manual page 20

Windows 95/98/Me Configuration
Configuring a Windows 95/98/Me computer
Install the NetBEUI protocol on the Windows 95/98/Me computer and set it as
the default protocol.
1
A A A A
Open [Control Panel], and then double-click the [Network] icon. Make sure
that "NetBEUI" is listed in the [The following network components are installed:]
box on the [Configuration] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add] on the [Configuration] tab
to install it. For more information about installing the NetBEUI protocol,
see Windows 95/98/Me Help.
❒ If "NetBEUI →Dial-Up Adaptor" is listed in the [The following network com-
ponents are installed:] box, select it and click [Remove] to remove the binding.
B B B B
Set the NetBEUI protocol as the default protocol. Click the [Configuration]
tab, select "NetBEUI" in the [The following network components are installed:]
box, and then click [Properties].
C C C C
Click the [Advanced] tab, select [Set this protocol to be the default protocol], and
then click [OK].
D D D D
Click [OK] to close the [Network] dialog box.
E E E E
When the message to restart appears, click [Yes].
14