Ricoh Aficio 615c Network Manual page 118

Monitoring and Configuring the Printer
Message
SMTPC: failed to connect smtp server.
2
SMTPC: username or password wasn't correct.
[response code] (information)
Snmp over IPv4 is ready
Snmp over IPv6 is ready.
Snmp over IPv4 over 1394 is ready.
Snmp over ipx is ready.
snmpd start.
started.
Started.
terminated.
The print server received error <error
number> during attempt to log in to the net-
work. Access to the network was denied. Ver-
ify that the print server name and password
are correct.
too many pictures.
trap account is unavailable.
usbd is disable.
WINS name registration: No response to serv-
er<WINS server address>
110
Problem and solutions
Connection to the SMTP server failed. This
could be because no connection to the network
has been established, or the network configu-
ration is incorrect, so there is no response from
the SMTP server, or the specified SMTP server
name is incorrect, or the specified SMTP server
IP address could not be found in the DNS serv-
er, or a server other than the SMTP server has
been specified, or the specified SMTP server
port number is incorrect. Check the DNS Serv-
er's IP address and SMTP server's IP address,
or the SMTP servername and SMTP port
number, or the SMTP server's SMTP port
number, or the network connection and con-
figuration.
Connection to the SMTP server failed, because
the specified SMTP user name is incorrect, or
the specified SMTP password is incor-
rect.Check the SMTP user name and password.
Communication over IPv4 with snmp is available.
Communication over IPv6 with snmp is available.
Communication over IPv4 over 1394 with
snmp is available.
Communication over IPX with snmp is available.
The snmpd service has started.
The direct print service has started.
The bonjour (rendezvous) function is enabled.
The bonjour (rendezvous) function is disabled.
Login to the file server failed.The print server
is not registered or a password is specified.
Register the print server without specifying a
password.
PictBridge printing failed because too many
image are sent during one print transacation.
Reduce images at one print transaction.
v3Trap cannot be sent. This could be because
the Trap destination account is different from
the account specified by the printer.
Plug and Play function and printing is disabled
because usbd is disabled in the security mode.
Enable usbd in the security mode.
There was no response from the WINS server.
Check the correct WINS server address is en-
tered. Alternatively,check the WINS server is
functioning properly.