This user manual describes the features and how to configure Virtual Access GW1000M Series routers. Virtual Access GW1000M Series routers enable 3G or LTE connectivity in vehicles such as buses, taxis and fleet vehicles for applications such as passenger WiFi internet access, telemetry and employee WiFi access to corporate network services.
For detailed information on using UCI commands, read chapters ‘Router File Structure’ and ‘Using Command Line Interface’. 1.3 Safety Virtual Access routers must be installed by authorised personnel only. The router is complicated electronic equipment that may be repaired only by authorised and qualified personnel.
WEEE take back scheme. Virtual Access has agreements in place with recyclers in the EU and Ireland, who will take back WEEE from you. Please contact us for details of recyclers in your area.
Page 7
1.5.3.1 Caution statement for modifications CAUTION Any changes or modifications not expressly approved by Virtual Access (Ireland) Lts., could void the user’s authority to operate the equipment. 1.5.3.2 FCC ID The GW1042M-QFR has been approved for the following regulation: FCCID: 2ACWY1042QFR 1.5.3.3 Labelling...
2: GW1000M Series router hardware _______________________________________________________________________________________________________ 2 GW1000M Series router hardware 2.1 GW1000M Series router hardware model features 2.1.1 GW1000M with standard locking DC power connector Figure 1: GW1000M Series router front Figure 2: GW1000M Series router back GW1032M Dual SIM sockets Dual antenna SMA connectors for 3G main and aux GPS antenna with 3.3V active power feed...
2: GW1000M Series router hardware _______________________________________________________________________________________________________ GW1000M with isolated DC power connector Figure 3: GW1000M Series router front Figure 4: GW1000M Series router back GW1032M Dual antenna SMA connectors for 3G main and aux GPS antenna with 3.3V active power feed...
Power lead with 3 connectors for 12V permanent, 12V switched (ignition sense) • and ground 2.6 Compliance The GW1000M Series router is compliant and tested to the following standards: Safety EN60950-1: 2006 EN55022:1998 Class B and EN55024:1998 ETSI 301489-17 Environmental ETSI 300 019-1-3 Sinusoidal Vibration and Shock ETSI 300 019-2-3 Random Vibration.
3G or 4G networks. Please visit our website: www.virtualaccess.com or contact Virtual Access for more information. Right angle or straight Virtual Access supplies a wide range of antennas for WiFi. Please stubby antenna for WiFi visit our website: www.virtualaccess.com or contact Virtual Access connection for more information.
2: GW1000M Series router hardware _______________________________________________________________________________________________________ 2.10 Inserting a SIM card 1. Ensure the unit is powered off. 2. Hold the SIM 1 card with the chip side facing down and the cut corner front left. 3. Gently push the SIM card into SIM slot 1 until it clicks in.
Solid on Releasing after 30 seconds performs a normal reset. Table 4: GW1000M Series router reset behaviour 2.17.1 Recovery mode Recovery mode is a fail-safe mode where the router can load a default configuration from the router’s firmware. If your router goes into recovery mode, all config files are kept intact.
3: GW1000M Series LED behaviour _______________________________________________________________________________________________________ 3 GW1000M Series LED behaviour 3.1 Main LED behaviour There are five LEDs on the GW1000M Series router Figure 5: LEDs on the GW1000M Series router The possible LED states are: • • Flashing slowing (2 flashes per second) •...
The Ethernet port has two physical LEDs, one is green and one is amber. When looking at the port the green LED is on the left and is the only active LED. Figure 6: Ethernet LED on the rear of the GW1000M Series router No physical Ethernet link detected...
Need help?
Do you have a question about the GW1000M Series and is the answer not in the manual?
Questions and answers