Danger Of Electrocution; Choosing A Suitable Location - Philio PAN08-1 Quick Start Manual

For Instruction to http:// www.philio-tech.com
DANGER

Danger of electrocution!

All works on the device may be performed only by a qualified and licensed electrician.
Observe national regulations.
Any works introducing changes into the configuration must be always performed with
disconnected voltage.

Choosing a Suitable Location

1. Do not locate the Module facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the Module is 0°C~40°C.
3. Do not locate the Module where exists combustible substances or any source of
heat, e.g. fires, radiators, boiler etc.
4. After putting it into use, the body of Module will become a little bit hot of which
phenomenon is normal.
TM
Adding to Z-Wave Network
In the front casing, there is an include button with LED indicator below which is used
to carry out inclusion, exclusion, reset or association. When first power is applied, its
LED flashes on and off alternately and repeatedly at 0.5 second intervals. It implies
that it has not been assigned a node ID and start auto inclusion.
Auto Inclusion
The function of auto inclusion will be executed as long as the PAN08 does not have
Node ID and just connect the PAN08 to main power.
Note: Auto inclusion timeout is 2 minute during which the node information of
explorer frame will be emitted once every several seconds. Unlike "inclusion" function
as shown in the table below, the execution of auto inclusion is free from pressing the
Include button on the PAN08.
The table below lists an operation summary of basic Z-Wave functions. Please refer
to the instructions for your Z-Wave
Setup function, and to include/exclude/reset/associate devices
Function Description
No node ID The Z-Wave Controller does not allocate
a node ID to the PAN08.
1.
Inclusion
Put your Z-Wave controller into
inclusion mode by following the
(Add a new node)
instructions provided by the
controller manufacturer.
2. Pressing Include button three times
within 2 seconds will enter inclusion
mode.
1.
Exclusion
Put your Z-Wave controller into
exclusion mode by following the
(Remove an
instructions provided by the
existed node)
controller manufacturer.
2.
Pressing Include button three
times within 2 seconds will enter
exclusion mode.
3.Node ID has been excluded.
3
TM
Certificated Primary Controller to access the
LED Indication
LED 2-second on, 2-second
off
One press one flash LED
To support handling of
the device when already
installed the external switch
can be used for inclusion or
exclusion for 3 minutes after
power up.
One press one flash LED
To support handling of
the device when already
installed the external switch
can be used for inclusion or
exclusion for 3 minutes after
power up.
LED 0.5s On, 0.5s Off (Enter
auto inclusion)