Replacing The Touch Pad; Procedure; Post-Requisites - Dell Inspiron 14-7460 Service Manual

Replacing the touch pad

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Align the screw holes on the touch pad with the screw holes on the palm rest
and keyboard assembly.
2 Replace the four screws (M2x2) that secure the touch pad to the palm rest and
keyboard assembly.
3 Align the screw holes on the touch-pad bracket with the screw holes on the
palm rest and keyboard assembly.
4 Replace the three screws (M2x3) that secure the touch-pad bracket to the palm
rest and keyboard assembly.
5 Adhere the tape that secures the touch-pad bracket to the palm rest and
keyboard assembly.
6 Slide the status-light board cable into the connector on the system board and
close the latch to secure the cable.
7 Adhere the tape that secures the touch pad to the palm rest and keyboard
assembly.
8 Slide both ends of the touch-pad cable into their respective connectors on the
touch-pad assembly and system board and close the latches to secure the cable.

Post-requisites

1 Replace the battery.
2 Replace the base
60
computer. After working inside your computer, follow
After working inside your
cover.
computer. For more safety best
www.dell.com/
Before