Sanyo SAP-KMRV93GJH Technical & Service Manual page 50

NOTE
14
Operation with the Remote Control Unit (continued)
STEP 1 Press the MODE selector button and select the desired
mode.
For heating operation
For dehumidifying operation →
For cooling operation
STEP 2 To start the air conditioner, press the ON/OFF operation
button.
STEP 3 Press the temperature setting buttons to change the
temperature setting to the desired temperature.
Adjustable temperature range:
NOTE • Room temperature control works to ensure that the
temperature stabilizes within a range of ±2 °C of the
temperature setting. For this reason, the value displayed
on the remote control unit may differ from the actual
temperature setting. Before the temperature stabilizes,
this difference may exceed the ±2 °C range.
• The operating lamp of the indoor unit lights in one of the
colors shown below.
STEP 4 Set the FAN SPEED selector button to the setting you want.
(Refer to "Adjusting the Airflow Direction" on page 23.)
STEP 5 Press the FLAP button and set the airflow direction as
desired.
(Refer to "Adjusting the Airflow Direction" on page 23.)
To stop the air conditioner, press the ON/OFF operation button again.
• After the cooling or drying operation has stopped, the indoor fan runs
for about 30 seconds to dry out the inside of the air conditioner. (The
operating lamps remain off.) The flap closes after the fan has
stopped.
• If the room temperature rises above the temperature setting during a
drying operation, the unit performs similar operation to cooling, and
when the room temperature approaches the temperature setting, it
performs the humidity-priority drying operation.
• The drying operation does not serve to raise the room temperature.
(When the outside air temperature is low or when the heat quantity
inside the room is low, the room temperature will not rise.)
• A change made to the temperature setting remains stored in the
memory even after operation has stopped.
• If the temperature setting is lowered during a drying operation so that
the unit has switched to a cooling operation, the outdoor unit shuts
down for 3 minutes. (This happens only when one indoor unit is
used.)
• When the unit is running in the drying operation mode while the
temperature setting is higher than the room temperature, the
humidity may not be reduced. In a case like this, select a temperature
setting which is lower than the current room temperature, and
perform the drying operation.
This appliance has a built-in 3-minute time delay circuit to ensure reliable
operation. When the operation button is pressed, the compressor will
start running within three minutes. In the event of power failure, the unit
will stop.
Heating
Operating lamp Drying
Cooling
→
→
30 °C max.
16 °C min.
Red
Orange
Green
OI-563-14EG