Table of Contents
Advertisement
8
3 or 6 spokes
The wheel drive is designed to work with 3 spoke clamps on 4 or 8 spoke wheels. For cosmetic
Note:
reasons, however, you may want to fit an extra spoke clamp to the fourth spoke. Raymarine dealers can
supply an extra spoke clamp (part number A18089).
3. Drill the appropriate spoke clamp holes using the larger of the supplied drill bits (6.0 mm
or
1
/
in):
4
• drill from the inside, placing a piece of scrap wood under the cover to produce a clean
exit hole
• you will need to drill 4 new holes so the cover has 6 holes in total (2 for each spoke
clamp)
The spoke clamps will cover these exit holes, so they will not be visible when the wheel drive is
Note:
installed.
Top 2 spoke clamp holes
are pre-drilled
MK II Wheel Drive
4 or 8 spokes
Piece of scrap wood
Advertisement
Table of Contents
