Activating And Deactivating Bluetooth® Radio Interface; Assembling The Lawn Mower - Stihl RMA 443.2 C Instruction Manual

English
6.2 Displaying the Charge State
► Press button (1).
The LEDs illuminate green for approx. 5 sec‐
onds to indicate the charge state.
► If the right LED flashes green: charge the bat‐
tery.
6.3 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
21.1.
There is a malfunction in the mower or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
10
7 Activating and Deactivating Bluetooth® Radio Interface
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
8 Assembling the Lawn
Mower
8.1 Attaching the Handlebar
► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Place the lawn mower on a level surface.
► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
► Guide upper handlebar (2) into handlebar
bracket (4).
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
► Tighten bolt (5).
► Press cable (7) into holders (8).
0478-131-8346-C