Dodge HORNET 2024 Owner's Manual page 275

RF Exposure Requirements
To comply with FCC RF exposure compliance require-
ments, the device must be installed and operated to
provide a separation distance of at least 20 cm from all
persons.
This equipment complies with Canada radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance 20 cm between the radiator and
your body.
Key Fob Model FI7PE
US FCC - 2ADPXFI7PE
Canada IC - 12548A-FI7PE
This device complies with Part 15 of the FCC Rules and
with Innovation, Science and Economic Development
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d`Innova-
tion, Science and Economic Development applicables
aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no cause
interferencia perjudicial y
2. este equipo o dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar su
operación no deseada.
RF Exposure Requirements
To comply with FCC RF exposure compliance require-
ments, the device must be installed and operated to
provide a separation distance of at least 20 cm from all
persons.
This equipment complies with Canada radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance 20 cm between the radiator and
your body.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
Déclaration d'exposition aux radiations
Cet équipement est conforme aux limites d'exposition
aux rayonnements ISED établies pour un environne-
ment non contrôlé. Cet équipement doit être installé et
utilisé avec un minimum de 20 cm de distance entre la
source de rayonnement et votre corps
CUSTOMER ASSISTANCE
REMARQUE: Des changements ou des modifications
n'ayant pas été expressément approuvés par la partie
responsable de la conformité pourraient révoquer
l'autorisation d'utilisation de l'équipement.
DASM
US:
FCC ID: NF3-FR5CPCCF
HVIN: FR5CPCCF
This device complies with Part 15 of the FCC Rules.Op-
eration is subject to the following two conditions: 1. This
device may not cause harmful interference, and 2. This
device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications made to this equipment not
expressly approved by Robert BOSCH GmbH may void
the FCC authorization to operate this equipment. This
equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to
Part15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
273
10