Dodge HORNET 2024 Owner's Manual page 213

WARNING!
•
Take care not to allow the contents of the Tire Ser-
vice Kit to come in contact with hair, eyes, or cloth-
ing. Tire Service Kit sealant is harmful if inhaled,
swallowed, or absorbed through the skin. It causes
skin, eye, and respiratory irritation. Flush immedi-
ately with plenty of water if there is any contact
with eyes or skin. Change clothing as soon as
possible, if there is any contact with clothing.
•
Tire Service Kit sealant solution contains latex.
In case of an allergic reaction or rash, consult a
physician immediately. Keep the Tire Service Kit
out of reach of children. If swallowed, rinse mouth
immediately with plenty of water and drink plenty
of water. Do not induce vomiting! Consult a physi-
cian immediately.
NOTE:
Always follow applicable state and provincial laws. Con-
tact state and provincial Highway Safety offices for addi-
tional details.
To use your Tire Inflator Kit, proceed as follows:
1. Stop the vehicle in a position where you can repair
the tire safely. Activate the Hazard Warning Flashers
to make other drivers aware of your presence.
2. If equipped, use all available safety equipment
required by law.
3. Verify that the valve stem (on the wheel with the
deflated tire) is in a position that is near to the
ground. This will allow the Tire Inflator Kit hoses to
reach the valve stem and keep the tire repair kit flat
on the ground.
4. Place the gear selector to PARK (P).
5. Apply the Electric Park Brake and cycle the engine
OFF.
6. Insert the sealant cartridge containing the sealing
fluid in the proper compressor holder, pushing down
hard. Unscrew the tire valve cap, take out the filler
tube and tighten the fitting on the tire valve.
Attaching Filler Tube To Deflated Tire
2 — Sealant Cartridge
3 — Filler Tube
7. Make sure the compressor is switched off.
IN CASE OF EMERGENCY
8. Insert the plug into the vehicle's center console
power outlet, then start the engine.
Power Outlet Location
9. Switch the compressor on.
10. Inflate the tire to the pressure indicated on the tire
placard, located on the driver's side B-pillar or the
rear edge of the driver's side door
In order to obtain a more precise reading, check
the pressure value on pressure gauge with the
compressor off.
211
page 250.
7