System Configuration; Planning The Installation; Receiver - Raymarine AIS250 User Manual

C h a p t e r 2 : I n s t a l l a t i o n
2 . 4 S y s t e m c o n f i g u r a t i o n
The illustration below shows a basic installation for an AIS
system:
VHF
radio
VHF
antenna
AIS250

receiver

FM radio
2 . 5 P l a n n i n g t h e i n s t a l l a t i o n
When planning the installation and choosing locations for the
antenna and receiver, consider the following points:
NMEA Data
4.8 in/out
Multifunction
display
ACTIVE
DATA
OK
SeaTalk
NMEA 38.4 IN/OUT
R e c e i v e r
Warning: Potential Ignition Source! This product is NOT
approved for use where hazardous/flammable atmo-
spheres could occur, e.g. an engine room.
MAX 55 130
GPS
antenna
MIN -10 14
PAGE
WPTS
MOB
MENU
OUT
RANGE
IN
CANCEL
You should choose an installation site where the power cable
can be easily removed from the unit.
Protect the receiver from extremes of temperature.
DO NOT place the receiver near an engine, or where
fuel vapor could be present.
DO NOT install the receiver where it is likely to get
wet or where it can be splashed with water.
DO NOT install the receiver where it can be kicked or
trodden on.
1 1
D9063-1