Table of Contents
Advertisement
•
The charging station is connected to the power supply unit via a cord that must move away from the charging station on the
outside of the cutting area.
•
Position the power supply unit according to these rules:
-
in a well-ventilated area protected against atmospheric
EN
agents and direct sunlight;
-
preferably inside your home, a garage or shed;
-
if positioned outdoors, the robot must not be exposed to
direct sunlight and water. Therefore, it must be protected
inside a ventilated box. Do not position in direct contact with
the soil or humid environments;
-
position it on the outside of the lawn and not inside;
-
stretch out the excess cord going from the charging station
to the power supply unit. Do not shorten or lengthen the
cord.
•
The incoming section of the wire must be straight and aligned
perpendicularly to the charging station by at least 200 cm
(78.74 in.) and the outgoing section must move away from the
charging station; this allows the correct re-entry of the robot.
If the robot is installed near an area which has another robot
(from the same or another manufacturer), then the transmitter and
receiver of the robot must be modified during installation so that
the frequencies of the two robots do not interfere with other. In this
situation, contact the closest customer service centre.
User's manual
OK
NO
NO
power supply unit
charging station
min height 160 cm
/ 63 "
min. distance
200 cm
/ 78,74 "
10
OK
NO
NO
transmitter
OK
NO
Advertisement
Table of Contents
