Dometic PERFECTWALL PW3500 Operating Manual page 20

Adjusting the awning
Step 3: Reprogramming the motor and remote control
➤ Switch off the awning power supply with the main switch for 10 seconds.
➤ Switch the power supply on again.
✓ The receiver beeps once briefly.
➤ Press the programming button briefly within 4 seconds in the battery
compartment of the remote control (fig. 3 2, page 2).
✓ The receiver beeps once briefly.
➤ Press the programming button again briefly in the battery compartment of the
remote control (fig. 3 2, page 2).
✓ The receiver beeps once briefly.
➤ Briefly press the
✓ The receiver beeps four times briefly.
✓ The awning moves twice briefly.
✓ The remote control and awning are now adjusted to each other.
➤ Check the function of the awning, see chapter "Retracting the awning" on
page 13 and chapter "Extending the awning" on page 12.
➤ If the awning fails to respond to the remote control, repeat step 3.
➤ Reprogramme the wind sensor, see chapter "Reprogramming the wind sensor"
on page 17.
20
button.
PW3500
EN