SERVICE WORK ON THE ENGINE 18
–
Remove screws
ring.
V01397-10
–
6
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surface.
V01398-10
–
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
–
Place the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
V01397-11
–
Stand the motorcycle upright.
–
Remove filler plug
oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
S03569-10
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check it for leaks.
5
. Take off the oil filter cover with the O-
out of the oil filter housing.
7
.
M6
10 Nm (7.4 lbf ft)
8
with the O-ring, and fill up with engine
1.0 l (1.1 qt.)
Engine oil (SAE
10W/50)
(
p. 147)
129