Troubleshooting; Service Information; Product Registration; One Year Limited Warranty - DeWalt DXAEC801B Instruction Manual

CLEANING AND STORAGE
• Store the unit in a clean, dry, cool place when not in use.
• Clean the unit casing and cords (as necessary) with a dry cloth.
Ensure that unit is completely disconnected from battery and power
source before cleaning.
• Do not immerse the appliance in water.
• To maintain the operating condition and maximize the life of the
charger cords, always coil them loosely on the built-in storage spool
when not in use. Do not wrap them around the unit or crimp them
with a tight band.
REPLACING THE 120V AC PASS THROUGH FUSE
The fuse that protects the AC Pass-Through circuit is located on the
back of the unit (see Fig. 2) within the Fuse Holder. The Fuse Holder
features a groove to allow locking or unlocking using a small coin or
screwdriver.
NOTE: Remove the clamps from the clamp holders before proceeding
with the fuse replacement procedure.
1. Use a coin, screwdriver, or other appropriate tool. Align it and
push it forward into the groove of the Fuse Holder, then slightly
rotate it counterclockwise about 90 degrees until the Fuse Holder
is automatically released.
2. Remove the fuse from the Fuse Holder and check it with a continuity
checker.
3. If the Fuse is blown, locate a replacement 6A fuse.
4. Replace the Fuse into the Fuse Holder.
5. Replace the Fuse Holder by placing it back in position. Then use
a coin, screwdriver, or other appropriate tool aligned in the groove
of the Fuse Holder, to push it forward, and then slightly rotate it
clockwise about 90 degrees until the Fuse Holder locks back into
the unit. Do NOT overtighten.
DXAEC801B_DXAEC801BCA_ManualENFRSP_080320.indd 18-19

Troubleshooting

Problem Possible Solution
Unit fails to turn on Check that the charger is properly
connected to a live 120 volt AC outlet.
Unit fails to charge Check that the charger is properly
connected to a live 120 volt AC outlet.
If the battery to be charged has fallen
below 2 volts, the battery cannot be
recharged with this charger.
Make sure a proper polarity cable
connection has been established.
AC Pass Through Check that the battery charger is properly
will not power connected to a live 120 volt AC Outlet.
appliance
Make sure the appliance is properly
connected to the AC Pass Through and
that the appliance is turned on.
Mark sure that the total draw of the AC
appliance connected to the AC Pass
Through does not exceed 700W.
Check that the fuse inside the fuse holder
at the back of the unit is not blown.
Replace the fuse with the same type and
size (250V / 6A) if it is blown.
18
Problem Possible Solution
USB Port will not Make sure the USB Power Button has
power appliance been turned on.
Make sure the USB Power/Fault Indicator
lights solid blue. If a fault condition exists
in the USB Port, the USB Power/Fault
Indicator will flash blue. Refer to the
Important Notes in the "Using the USB
Port" section to remedy any faults.
Make sure that the draw of the USB
device plugged into the USB Port does
not exceed 5V/3.1A.
Some USB-powered household electronics
will not operate with this USB charging/
power port. Check the manual of the
corresponding electronic device to confirm
that it can be used with this type of USB
charging/power port.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this unit could be hazardous. To reduce the risk of
injury, only D WALT recommended accessories should be used with
e
this product.
If you need assistance regarding accessories, please contact Baccus
at 1-888-394-3392 or CustomerService@dewalt12volt.com.

Service Information

Whether you need technical advice, repair, or
factory replacement parts, please contact Baccus
1-888-394-3392 or CustomerService@dewalt12volt.com.

Product Registration

Please complete the Product Registration Card and return within
30 days from purchase of the product to: Baccus Global LLC, 621
NW 53rd St., Suite 450, Boca Raton, FL 33487. Baccus Global
LLC, toll-free number: 1-888-394-3392. www. dewalt12volt.com.

One Year Limited Warranty

The warranty of this product is covered by Baccus Global LLC
(1-888-394-3392 or CustomerService@dewalt12volt.com). The
manufacturer warrants this product against defects in material and
workmanship for a period of one (1) year from the date of retail
purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty
Period, the defective product can be repaired, replaced or refunded,
without charge, in the following ways: (1) Return the product to the
manufacturer for repair, replacement or refund at manufacturer's option.
Proof of purchase may be required by manufacturer. (2) Return the
product to the retailer where product was purchased for an exchange
(provided that the store is a participating retailer). Returns to retailer
should be made within the time period of the retailer's return policy for
exchanges only (usually 30 to 90 days after the sale). Proof of purchase
may be required. Please check with the retailer for their specific return
policy regarding returns that are beyond the time set for exchanges.
19
genuine
at
11/04/20 10:30 AM