Assembling The Light Kit - Hunter Beck Installation Manual

Partially install two light kit assembly screws, found in
the hardware bag, halfway into the motor housing
as shown. It does not matter which two screw holes
you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
Install a bulb into each of the sockets. When necessary, replace with
bulbs of the same wattage.
Repeat x2
Ceiling Bracket Downrod

Assembling the Light Kit

2 of 3
Light Kit Screw
bag
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 3
Light Kit Screw
bag
hardware
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the
Hanging Fan Wiring
hardware bag.
Light Kit
Align the globe indentations with the globe retainer screw holes
and carefully lower the globe into the globe retainer until it rests
in place.
Canopy Blades
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
2 of 2
Short Light Kit
Screw
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Light Bulb
1886
8
Pull Chain