Page 1
For parts and technical support, call the Industrial Coating Systems Customer Support Center at (800) 433-9319 or contact your local Nordson representative. This document is subject to change without notice. Check http://emanuals.nordson.com for the latest version. NORDSON CORPORATION • AMHERST, OHIO • USA...
Nordson Corporation welcomes requests for information, comments, and This is a Nordson Corporation publication which is protected by copyright. inquiries about its products. General information about Nordson can be found on Original copyright date 2013. No part of this document may be photocopied,...
Page 3
Stainless Steel NH-4 Thermostat/Heat Limiter Kit ............... External Adjust Kit (OBSOLETE) ....................Manual Reset Thermostat Kit — Japan Only ................Standard NH-4 Single Passage Fluid Reservoir Seal Kit ............. Standard NH-4 Twin Passage Fluid Reservoir Seal Kit ............... Stainless Steel Alternate Fitting....................
Intended Use Use of Nordson equipment in ways other than those described in the documentation supplied with the equipment may result in injury to persons or damage to property. Some examples of unintended use of equipment include: •...
4. Fluid inlet 6. Electrical enclosure See Figure 1. The standard NH-4 heater is available in both aluminum and stainless steel versions. Refer to the Parts section for a complete listing of available heaters. The heater can be wall or dolly mounted. The heater consists of an electrical enclosure (6) and a fluid section.
6. Fluid passage body Identifying Groups of Heaters This manual covers different types of NH-4 heaters. When procedures or data differs, the following codes will be used: [EXT ADJ]—This code is used for NH-4 heaters that have an external adjustable thermostat control.
See Figure 3. Mount the NH-4 heater in a vertical position on a wall or panel, allowing adequate surrounding space to perform periodic maintenance. Always locate the heater as close to the spray operation as possible.
22 mm (0.875 in.) Inlet 98 mm (3.54 in.) Figure 3 NH-4 Heater Dimensions Electrical WARNING: Install a power isolation device or disconnect in the service line ahead of the heater to prevent electrical shock during installation or servicing. 1. Remove the enclosure cover.
THREE PHASE THREE PHASE L2 L1 L2 L1 Figure 4 NH-4 Heater Wiring Diagrams Fluid Lines and Fittings CAUTION: The heater inlet and outlet fittings use O-ring seals which form a leak-proof hydraulic seal if tightened properly. To prevent damage to the seals, do not over-tighten fittings.
CAUTION: Use the stainless steel thermometer and fittings with the stainless steel NH-4 heater to prevent damage to the equipment. NOTE: If the thermometer is installed after the filter, use the hex nipple included with the heater installation to install the adapter to the filter.
This section covers safety precautions, and single and multiple heater operation procedures for the NH-4 heater. When a procedure is only applicable to a particular model it is identified with a code. Refer to the Description section for an explanation of these codes.
• Replace the hose with an insulated hose • Relocate the hose or heater • Install an additional NH-4 heater assembly Shutdown CAUTION: Always shut down the heater and continue to circulate coating material through the heater as it cools to avoid material curing inside the heater fluid passages.
16 NH-4 Heaters Daily Maintenance WARNING: Allow only qualified personnel to perform the following tasks. Follow the safety instructions in this document and all other related documentation. WARNING: Use appropriate respiratory and skin protection when using coating materi- als and solvents. Obtain and read the Material Data and Safety Sheets from the manu- facturer before use, and follow manufacturer’s recommended handling and disposal...
Allow only qualified personnel to perform the following tasks. Follow the safety instructions in this document and all other related documentation. These troubleshooting procedures cover only the most common problems. If you cannot solve a problem with the information given here, contact your local Nordson representative for help. Problem...
18 NH-4 Heaters Repair WARNING: Allow only qualified personnel to perform the following tasks. Follow the safety instructions in this document and all other related documentation. WARNING: Remove power, relieve fluid and air pressure, and allow the heater to cool down before performing any repairs.
20 NH-4 Heaters Heat Limiter Replacement WARNING: Remove power, relieve fluid and air pressure, and allow heater to cool down before performing any maintenance. Failure to observe this warning may cause serious injury to personnel and/or damage to equipment. 1. Remove the thermostat. Refer to Thermostat Removal procedure.
22 NH-4 Heaters High Pressure Housing Removal − Standard Heaters Only See Figure 9. 1. Remove the retaining ring (6) from the fluid passage body (2). 2. Place a wooden block on a hard surface. Grasping the reservoir assembly firmly, strike the top surface of the fluid passage body against the wood block until the lower O-ring (5) is exposed.
NH-4 Heaters Parts For parts and technical support, call the Industrial Coating Systems Customer Support Center at (800) 433-9319 or contact your local Nordson representative. Heater Reference Chart NOTE: Heaters are equipped with internal temperature adjustment unless otherwise specified. Heat Limiter/...
Page 33
NOTE: A. Not serviced separately. B. Heater, part 247748, has a quantity of three screws, part 982005. C. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. D. Part is included in the Standard Thermostat Kit, part 106283.
Page 35
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Single Passage Reservoir Seal Kit, part 106282.
Page 37
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Single Passage Reservoir Seal Kit, part 106282.
• SCREW, chez, HD , slot, M4 X 12, zinc 245896 • FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Stainless Steel NH-4 Thermostat/Heat Limiter Kit, part 106356. C. Part is included in the Standard Thermostat Kit, part 106283. NS: Not Shown 1602369-05...
Page 47
NOTE: A. Not serviced separately. B. Obsolete heater 247747 uses three screws, part 982005. C. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. D. Part is included in the Standard Thermostat Kit, part 106283. E. Part is included in the Single Passage Reservoir Seal Kit, part 106282.
Page 49
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Twin Passage Reservoir Seal Kit, part 106310.
Page 51
NOTE: A. Not serviced separately. B. Part is included in the Standard Thermostat Kit, part 106283. C. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. D. Part is included in the Twin Passage Reservoir Seal Kit, part 106310.
Page 53
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Single Passage Reservoir Seal Kit, part 106282.
Page 57
NOTE: A. Not serviced separately. B. Heater, part 247748, has a quantity of three screws, part 982005. C. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. D. Part is included in the Standard Thermostat Kit, part 106283.
Page 59
• SCREW, chez head, slotted, M4 x 12, zinc NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Twin Passage Reservoir Seal Kit, part 106310.
Page 61
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Twin Passage Reservoir Seal Kit, part 106310.
Page 63
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Single Passage Reservoir Seal Kit, part 106282.
Item Part Part Description Quantity Note — 245676 HEATER, NH-4, 460 Volt (OBSOLETE) HEATER, NH-4, 460 Volt, twin passage, 1700 watt — 247480 (OBSOLETE) 982006 982006 • SCREW, socket head, M8 x 20, zinc 983150 983150 • LOCK WASHER, split, 5/16 in., steel, nickel...
Page 65
• FEED THRU, two-wire NOTE: A. Not serviced separately. B. Part is included in the Standard NH-4 Thermostat/Heat Limiter Kit, part 106363. C. Part is included in the Standard Thermostat Kit, part 106283. D. Part is included in the Single Passage Reservoir Seal Kit, part 106282.
106362 THERMOSTAT SERVICE KIT, manual reset 248093 • THERMOSTAT, dual, with bracket 245773 • APPLICATOR, heat conductive paste, 1 cc Standard NH-4 Single Passage Fluid Reservoir Seal Kit Part Description Quantity 106282 SINGLE PASSAGE SEAL SERVICE KIT, heater, NH-4 945017 •...
HEATER CARTRIDGE, 200V/1700W (twin passage) 246243 HEATER CARTRIDGE, 230V/1000W Recommended Spare Parts Keep the following parts in inventory to avoid unplanned downtime. Quantities listed support a single NH-4 heater. Adjust order quantities based on the number of heaters in service. Part Description Quantity...
Page 77
Amherst, Ohio, USA Nordson Authorized Representative in the EU Person authorized to compile the relevant technical documentation. Contact: Operations Manager Industrial Coating Systems Nordson Deutschland GmbH Heinrich-Hertz-StraBe 42-44 D-40699 Erkrath Nordson Corporation • 555 Jackson St, Amherst, Ohio 44001. USA DOC13029-04...
Page 78
Industrial Coating Systems Amherst, Ohio, USA Nordson Authorized Representative in the UK Contact: Technical Support Engineer Nordson UK Ltd.; Unit 10 Longstone Road Heald Green; Manchester, M22 5LB. England Nordson Corporation • 555 Jackson St, Amherst, Ohio 44001. USA DOC13038-01...