Advertisement
Quick Links
SERIAL-BT-ADP Getting Started
TM
Ocean Optics is offering the SERIAL-BT-ADP serial-to-Bluetooth
adapters for replacing an RS-232
cable in your system with a wireless connection for operating at a distance of up to 300 feet (100 meters).
A pair of these Bluetooth devices works with an RS-232 serial interface to a computer, or other
equipment using serial data format, replacing a dedicated cable connection with no need for any software
changes.
The adapters are used in pairs to replace a direct serial data cable connection anywhere in your laboratory
or industrial system. Simply disconnect each end of the RS-232 cable and connect the correct adapters
(male or female) to the equipment at each end of the link. See the example below using an STS
spectrometer.
100-40000-032-01-201203b
1
Advertisement
Related Manuals for Halma Ocean Optics BT-ADP Series
Summary of Contents for Halma Ocean Optics BT-ADP Series
- Page 1 SERIAL-BT-ADP Getting Started Ocean Optics is offering the SERIAL-BT-ADP serial-to-Bluetooth adapters for replacing an RS-232 cable in your system with a wireless connection for operating at a distance of up to 300 feet (100 meters). A pair of these Bluetooth devices works with an RS-232 serial interface to a computer, or other equipment using serial data format, replacing a dedicated cable connection with no need for any software changes.
- Page 2 SERIAL-BT-ADP Getting Started Instructions For systems that are already capable of communicating using Bluetooth, such as a PDA, tablet computer, laptop, or smart phone, the adapters can be used individually. This allows you to share one or more data acquisition devices, each equipped with this adapter, among several users. When using the adapter individually, application software (possibly custom, not included) is required for your device to communicate with the Bluetooth module.
- Page 3 SERIAL-BT-ADP Getting Started Instructions 9600 Baud Rate Switch Settings This is the default baud rate for most Ocean Optics spectrometers: Maya2000 Pro, NIRQuest, QE65000, STS, Torus, USB2000+ and USB4000. Unit 1 (master) switch settings: 9.6K/115K baud Switch 4 = on Auto Master Switch 3 = on Auto Discover...
- Page 4 SERIAL-BT-ADP Getting Started Instructions Note Once the SERIAL-BT-ADP devices have been successfully paired, set Switch 2 (Automatic Discovery) to off to prevent them from inadvertently pairing with any other Bluetooth devices within range. 57600 Baud Rate Switch Settings This is the default baud rate for the Jaz spectrometer. Reset the Jaz baud rate to 115200 baud using the Jaz Serial Bus menu as described in the Jaz Installation and Operation Manual, then set the SERIAL-BT-...