NordicTrack NTL14117.1 User Manual page 14

10. IMPORTANT: To avoid damaging the Pulse
Crossbar (80), do not use power tools, and do
not overtighten the #10 x 3/4" Screws (6) or
the 5/16" x 2" Screws (2).
Orient the Pulse Crossbar (80) as shown. Attach
the Pulse Crossbar with two 5/16" x 2" Screws
(2), two 5/16" Star Washers (8), and two #10 x
3/4" Screws (6); start all four Screws, and then
tighten them.
Then, tighten the other two 5/16" x 2"
Screws (2).
11. With the help of a second person, hold the con-
sole assembly (H) near the Handrails (74).
See the inset drawing. Connect the Upright
Wire (83) to the console wire (J). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
Then, remove any wire ties (K) from the Upright
Wire (83).
10
6
2
8
2
11
H
J
83
74
K
14
80
2
6
8
2
J
83