7 PREPARING FOR USE
–
Make sure that no radiator covers are installed.
Difficult operating conditions are:
–
–
–
–
–
7.4
22
–
Clean and dry the connector, or change it if necessary.
Rides on dry sand. (
p. 22)
Rides on wet sand. (
p. 23)
Rides on wet and muddy circuits. (
Rides at high temperatures and slow speed. (
Riding at low temperatures and in snow. (
Preparing vehicle for rides on dry sand
M01129-01
M01104-01
p. 25)
p. 25)
p. 26)
–
Check the radiator cap.
Value on the radiator cap
»
If the indicated value does not correspond to the setpoint
value:
Warning
Danger of scalding During motorcycle oper-
ation, the coolant gets very hot and is under
pressure.
–
Do not open the radiator, the radiator hoses
or other cooling system components if the
engine or the cooling system are at operat-
ing temperature.
–
Allow the cooling system and the engine to
cool down before you open the radiator, the
radiator hoses or other components of the
cooling system.
–
In the event of scalding, rinse the area
affected immediately with lukewarm water.
–
Change the radiator cap.
–
Mount a dust cover on the air filter.
Dust cover for air filter (79006920000)
Info
Observe fitting instructions for KTM PowerParts.
1.8 bar (26 psi)