Using The Grip Ring With Led Light; Notes On Working With Materials/Tools/Speed Range - Parkside 286851 Translation Of The Original Instructions

Using the grip ring with LED light

♦ Unscrew the union nut
thread.
♦ Screw the grip ring with LED
the screw thread.
♦ Move the ON/OFF switch of the LED light
the position "I" to switch it on (see fig. C).
♦ Move the ON/OFF switch of the LED light
the position "O" to switch it off again.
Notes on working with materials/
tools/speed range
■ Use the milling bit for working on wood, plastics
and plasterboard at maximum speed.
■ Calculate the rotational speed range for working
on zinc, zinc alloys, aluminium, copper and
lead by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
in the middle range.
NOTE
► The milling bit is not suitable for steel or
iron. Suitable products are available in stores.
PFBS 160 B2
anticlockwise off the
clockwise onto
to
to
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which
settings are ideal for the material you are working
on.
Set a suitable rotational speed:
Number on the speed
control
1
2–3
4
5
Max.
GB │ IE │ NI │ CY
Material being
worked
Plastics and materials
with a low melting
point
Stone, ceramics
Soft wood, metal
Hardwood
Steel
│
11 ■