Modena WP 7134 WVM User Manual Book page 10

Water Connection
Connect the cold-water supply hose to
a threaded 3/4-inch connector and
make sure that it is fastened tightly in
place. If the water pipes are new or
have not been used for an extended
period, let the water run first to make
sure that the water is clean and free of
dirt. If this precaution is not taken, there is a risk that the water inlet
can get blocked and thus damage the appliance.
Please Note: If the supplied hose does not fit your tap, please contact
your local plumbing supply center where adapters are available for
purchase.
Drain Hose Connection
Insert the drain hose into a drainpipe with a minimum diameter of 40
mm, or let it run into the sink, make sure to avoid bending or crimping
the hose. The height of drainpipe must be less than 1000 mm. The
free end of the hose must not be submerged in water to avoid the
back flow of it. Ensure the drain hose is locked properly in either
position A or position B!
Counter
Back of dishwasher
Drain hose
Water inlet
Back of dishwasher
Main cable
10