Electrolux EVEP604 User Manual page 65

TROUBLESHOOTING
NOTE: We may charge for service even in the warranty period if your problem is due to the causes listed below.
problem
Oven or grill not working
Oven light not working
Oven not heating enough
Clock flashing on display
Unit smoking when first used
Condensation build up
Door cannot be replaced after removal
Pyrolytic cycle not working
Functions and temperature appear on display but
oven does not work
When the door is open the fan stops
(underbench only)
When a non fan mode is selected the fan starts
The light stays on when the door is closed
The light does not turn *ON* when the door is
opened
Error message "REMOVE FOOD PROBE" after
connecting Food Probe to appliance
Food Probe temperature setting not displayed
When using the Food Probe, centre of the food is
undercooked
Data plate
When you need information, service or spare parts please
be prepared to tell us the:
Model number: ____________________________________
Serial number: _____________________________________
These are shown on the data plate. The data plate is visible
when the oven or grill door is open.
possible cause
• Time of day is not set.
• Power is not turned on.
• Controls are incorrectly set .
• Oven is in 'Demo' mode, refer to Additional Functionality.
• Household fuse has blown or power supply is off. (If the household fuse
continues to blow, call the Service Centre).
• Child-proof oven lock is activated. 'LOCKED' is displayed when control is
touched. (Refer to operating instructions).
• Light may be turned off at control panel.
• Lamp blown or loose socket.
• Household fuse has blown. (If the household fuse continues to blow, call the
Service Centre).
• Foil trays on bottom of oven.
• Timer is in 'AUTO' mode. (Refer to operating instructions).
• Household fuse has blown or power supply is off. (If the household fuse
continues to blow, call the Service Centre).
• Reset time of day and any cooking functions you were using.
• Protective oils being removed.
• Reduce the amount of water used in cooking. (Sometimes condensation is
normal).
• Stirrup not engaged properly.
• All accessories must be removed from the ovens.
• Oven is in 'Demo' mode, refer to Additional Functionality.
• This is a function of the power board to help reduce the blast of air when
opening the door.
• Most oven modes have a fast heat up function that uses the fan, fan
element and top (boost) elements. Auto fast heat up can be overridden by
selecting a temperature of 120°C or less, allowing the function to start, then
increasing the temperature to the desired level.
• An oven function has been selected.
• The light has been turned on at the control panel.
• Oven light may need replacing.
• The cooking function selected is not compatible with the food probe. Refer
Food Probe instructions page.
• Ensure Food Probe plug is fully inserted into the socket on the front panel.
• Incorrect Food Probe used. Only use the Food Probe recommended for
this appliance.
• Ensure food is fully defrosted
• Ensure the Food Probe is inserted at least 75% into the food.
•
Ensure that food has been adequately rested after cooking.
Customer Care Centre
If you need more information, please contact the Customer
Care Centre:
Australia – 1300 363 640, 8am – 5pm EST Mon – Fri.
New Zealand – +649 573 2384, 8am – 5pm EST Mon – Fri.
If you have a warranty or spare parts enquiry, you should call
the number listed on the back page.
65