Table of Contents
Advertisement
Energy Saver
menu item
Network
menu item
Music services
menu item
18
The MP 2500 R features two stand-by modes: ECO Standby with reduced
stand-by current drain, and Comfort Standby with additional functions, but
slightly higher current drain. You can select your preferred stand-by mode in
this menu point:
On (ECO standby):
Active functions in ECO standby mode:
Power-on at the device itself, or by remote control.
Automatic power-down after ninety minutes without signal (only possible
with certain sources).
Off (Comfort standby):
The following expanded functions are available:
On / Off button illuminated in stand-by mode.
Unit can be switched on using the app.
Can be switched on using the FD100 radio remote control handset
(the FD100 is an optional accessory)
The automatic power-down function is disabled in Comfort standby mode.
All network settings can be carried out at this menu point. For a detailed
description on setting up a LAN or WLAN connection please also refer to the
section entitled "Network configuration" on page 51.
At this point you can enter the access data for the music streaming services
Qobuz and Deezer.
TIDAL uses a special procedure for entering the access data. For this reason,
the data must be entered via the T+A Music Navigator app (please see next
page for details). If necessary, you can delete them later under this menu item.
Calling up this menu point by pressing the button displays a list of the
supported music services.
Select the service you wish to use, then confirm your choice with the
button.
Now use the alpha-numeric keypad of the SRC1 to enter the access data
which you have received from your service provider in the lines "User" and
"Passphrase".
Use the button to switch between numeric and alpha-numeric input,
and between capitals and lower-case letters.
Press the button to erase any letter.
In each case confirm your input of user name and password by pressing the
button.
To conclude the procedure and save the data, select the menu entry "Store
and exit?" and confirm by pressing the button.
If access data for the selected music service has already been stored, the new
data will overwrite them. To use the new access data you must first perform a
"Logout" for the service in question, then switch the MP 2500 R off and on
again.
The music streaming services supported by the MP 2500 R require a
subscription to the appropriate service provider.
TIDAL credentials (since firmware version1.40)
To enter the TIDAL credentials, open the T+A Music Navigator App and select
the TIDAL source. Are no credentials stored, an internet browser with the
TIDAL log-in window will open automatically. Enter your credentials here and
confirm the entry. As soon as the login has been successfully completed, you
can close the Internet browser and return to the T+A app. Your data is now
automatically saved and TIDAL is available.
We recommend that you enter your TIDAL credentials via our app.
If no mobile device is available, the procedure can alternatively be carried out
via the Internet browser of your PC. For this, call up the TIDAL source on the
MP 2500 R and press the i button on the remote control or on the device. An
Internet address and an activation code are displayed on the MP 2500 R. Enter
the address in the browser and open the page. Enter the activation and
confirm. You will be automatically redirected to the TIDAL log-in page. Log in
here with your credentials. The device is now logged in to TIDAL.
Advertisement
Table of Contents
