Table of Contents
Advertisement
Door Installation:
1. Locate inside door (sticker to identify door in lower corner of door)
2. Place black spring closure tab at rear top of door.
3. Pick up on door
4. Insert lower part of door in to track when door is 3" open
5. Assure door spring forces door closed
6. Repeat for outside door.
Door Adjustment:
Roller bearings on bottom of each door may be adjusted to allow for proper seal of
glass door. To look for proper door sealing assure that the bumper gasket of each
door touches the entire vertical side of the door frame. No gaps should be visible
NOTE: The design of the bumper gasket does allow for a small 1/8" gap at
top of each door.
NOTE: DO NOT USE SHARP UTENSILS.
14
14
800-621-8560
14
14
Preventive Maintenance (cont.)
Advertisement
Table of Contents
