Hyundai KH-G03-T Owner's Manual page 47

Turn on the power.
11
test run
Use tweezers
remove the test
tying wire
Before starting overhaul, please switch off the equipment. Disconnect the
connection between battery and the equipment, and place battery in a safe
package.
Cleaning and maintenance
1.Don't spray water on the equipment or immerse it in water, otherwise the equip-
ment will be damaged.
2.It shall be cleaned with a wet cloth or a hair brush. Don't use any cleaning agent;
otherwise it may cause permanent damage to the equipment.
3.Each time after one roll of tying wire is used up, please use tweezers or a brush to
clear up foreign matters in track.
4.After continuing working for 8 hours, use tweezers or a brush to clear up foreign
matters in track. Check if the pin, retaining ring, and spring of each movable joint
have any foreign matters, if there are any foreign matters, remove them timely.
Fill sufficient lubricating oil at cutter and each joint. Good maintenance habit can
extend the service life of the product effectively.
Install the back cover.
complete！
Opens pressing plate
E NGLISH
47
12
Use a hair brush to
cleaning the guideway
12