Troubleshooting; Technical Data - BOMANN 773380 Instruction Manual

NOTE:
To speed up the defrosting process, make use of the
included ice scraper.
To achieve better cooling and to save energy, defrost
the appliance regularly as follows:
• To start the defrosting process, disconnect the ap-
pliance from the power supply.
• Remove the appliance content and keep covered
at a cool location.
• Open the water discharge channel at the appli-
ance bottom and the water discharge opening at
the appliance front. Place a drip tray under to
catch leaking water.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Replacing the lid hinge
If the appliance lid does not stay up after opening,
this is probably due to a worn or damaged hinge.
It is recommended to replace all hinges at the same
time, otherwise the next repair will soon be beckon-
ing.
• If necessary, remove the contents of the appli-
ance and the interior fittings.
• Carefully remove both hinge cover caps and dis-
assemble the hinge with the lid in the open posi-
tion.
First loosen the screws at-
tached to the lid and then the
screws attached to the rear
wall.
• The hinges are mounted in reverse order.
• Open the appliance lid for a test run, readjust the
hinges if necessary. In any case, make sure that
the lid fits tightly and accurately.

Troubleshooting

Before you contact an authorized specialist
Problem / Cause / Action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the appliance in the last 24 hours.
- The appliance lid is not closed properly, check
the lid seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
Water on the appliance bottom
Check the temperature setting / water discharge
channel or opening.
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.

Technical Data

Climate class N/ST: this appliance is intended to be
used at ambient temperature ranging from 16°C to
38°C.
Electrical connection............................................
Power voltage: .........................220-240 V~ / 50 Hz
Rated (defrost) power: ................................150 W
Rated current: ...............................................1.5 A
Dimension H x W x D / Weight...............................
Appliance size: .......................85.0 x 90.5 x 55.0 cm
Net weight: ..................................approx. 31.0 kg
24
.