Coolant - Yamaha DIVERSION F 2010 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on the center-
stand.
2. Remove cowling A. (See page
6-8.)
TIP
G The coolant level must be checked
6
on a cold engine since the level
varies with engine temperature.
G
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
3. Check the coolant level in the cool-
ant reservoir.
TIP
The coolant should be between the
minimum and maximum level marks.
EAU20070
2
3
EAU50540
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
4. If the coolant is at or below the
minimum level mark, remove cowl-
ing C. (See page 6-8.)
5. Remove the coolant reservoir
breather hose from the guide, and
then remove the coolant reservoir
cap.
6-15
1
1
1. Coolant reservoir cap
2. Coolant reservoir breather hose
3. Guide
6. Add coolant to the maximum level
mark, and then install the coolant
reservoir cap. WARNING! Re-
move only the coolant reservoir
cap. Never attempt to remove
the radiator cap when the en-
gine is hot.
coolant is not available, use dis-
tilled water or soft tap water in-
stead. Do not use hard water or
salt water since it is harmful to
the engine. If water has been
used instead of coolant, replace
it with coolant as soon as possi-
ble, otherwise the cooling sys-
tem will not
2
3
NOTICE: If
[EWA15161]
be protected