Tray Mounts; Accessory Ports; Setting Up Your Camera; Pre-Installation Checklist - Ikelite 6950.53 Manual

Tray Mounts

This housing features two 1/4-20 threaded tray mounts on the bottom
of the housing. The spacing between the tray mounts is 3" (76.2 mm).
Optional tray with handles and mounting hardware are sold separately.
It is recommended to detach and thoroughly rinse the tray mounts,
tray, and mounting hardware, with fresh water routinely during
continuous use and prior to storage.

Accessory Ports

This housing features a spare accessory port which may be used
for the attachment of optional accessories. This port accepts fittings
designed for a 1/2" through or 1/2-20 threaded hole.
The optional Vacuum Kit # 47012 may be installed in place of the side
accessory port. A hand pump with gauge allows you to draw a vacuum
on the house to simulate water pressure and check for leaks prior to
entering the water.
Visit ikelite.com for an updated list of compatible products.
Do not remove or loosen the accessory port plug unless you
»
are installing a compatible accessory.

Setting Up Your Camera

Pre-Installation Checklist

1. Insert a fully charged camera battery.
2. Insert a properly formatted memory card.
3. Remove any attached lanyard or neck strap.

Camera Settings

•
EVF Auto Switch
Set to "Off."
9