Ikelite 6950.53 Manual page 26

•
Restore the camera to factory default settings. There are some
camera settings that will prevent an external flash from firing.
•
Check camera settings recommended for use with an external
strobe in the beginning of this manual.
•
Check that the electrical sync cord is properly attached.
•
If using, check that the hotshoe is pushed all of the way forward on
the camera.
Button(s) are sticking
•
Soak the housing in lukewarm fresh water. Depress each button
several times while the housing is submerged. Rinse the housing
with running fresh water.
•
Lubricate the controls.
Button(s) or control(s) not operating
•
Tighten the camera mounting plate with a screwdriver.
•
Ensure that nothing is preventing the camera from going all of the
way into the housing.
•
Check that the camera mounting plate is pushed all of the way
forward.
Camera is not functioning normally underwater
•
Check each housing control while underwater to ensure that
they are disengaged. An inadvertently engaged control may limit
functioning of the camera.
•
Check that no controls are being accidentally pressed.
•
Check that the shutter is not half depressed. If the shutter spring
has been damaged by activation without a camera installed, it may
not return properly. Adjust or replace the shutter spring.
26