Connecting using Wi-Fi Protected Setup
You can set up a connection quickly and easily using Wi-Fi Protected Setup. Refer to the instruction manual of your access point for further
information.
Note: If your access point is set to use WEP security encryption, you will be unable to connect your Nintendo system using Wi-Fi Protected Setup.
Touch
1
Note: If you are using the tutorial and you have selected
Touch the connection method supported
2
by your access point
Steps for the access point
3
Note: It may take around 2 minutes to complete setup.
For Push-Button Connection
Press and hold the Wi-Fi Protected Setup button on the access point until the LED blinks.
For PIN Connection
A PIN will be displayed on the Touch Screen. Enter the code into the access point
settings, then touch NEXT.
Note: After configuring the access point, touch NEXT on your system's Touch Screen.
Once the setup complete screen appears, touch OK to begin a connection test
4
•
If the test is successful, setup is complete.
•
Failure to establish a connection can sometimes occur after Wi-Fi Protected Setup is complete. If this happens, please wait a short
while before trying to reconnect.
36
, start from step
.
2
Wi-Fi Protected
Setup button